CNC Operator - 2nd Shift

Job Description

Job Req ID

30354

Work Type

Onsite

Department

Eaton’s IS AER FED division is currently seeking a CNC Operator - 2nd Shift. A

The hours for this role are 3p-11p

The hourly rate for this position is $24.50 per hour.

Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

What you’ll do :

Essential Functions :

• Be able to perform CNC set-ups and tool and material changes to execute a sequence of operations such as turn, drill, and bore a variety of metal components
• Follow procedure according to process documentation (router and process sheets)
• Can identify inserts, cutters and general tooling for specific operations
• Can inspect tooling condition and replace as necessary
• Interpret technical drawings in accordance with standard shop practices
• Measure seals using tools such as micrometers, pi tape, gauge, venires, etc. Check dimensions as indicated on the blueprints and process sheet and perform visual inspection
• Document and control dimension using the SPC (statistically process control)
• Participate in lean and 5S+ activities, as required.
• Assist in the development of new product and programs.
• Perform other related duties as assigned.

Qualifications :

Basic Qualification :

• High School Diploma, GED or equivalent from accredited institution
• Minimum of 2 years of work experience OR completion of a machinist / CNC degree / certification.
• This position requires use of information or access to hardware which is subject to the International Traffic in Arms Regulations (ITAR).

All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.

e. 'Green Card Holder'), Political Asylee, or Refugee.

• Authorized to work in the US without sponsorship.
• No relocation benefit is offered for this position. Only candidates residing within the immediate Beltsville area (50 miles) will be considered for this position.

Preferred Qualifications :

• 3 years manufacturing experience
• 2 years of CNC experience
• Familiarity with G Code

Position Criteria

Safety first focus factory which requires proper PPE where applicable. You must be able to lift up to 35 pounds within any given day.

The job could require standing on your feet anywhere from 8-10 hours a day. Will require focus evaluations from close proximity and frequent use of hand to eye coordination.

All the time

• Working with forming parts as stated above.
• Full use of both hands
• Walking
• Good finger dexterity
• Good vision
• Standing 8-10 hours a day

Most of the time

• Lifting 0-35 pounds approximately 3 times per day
• Exposure to oil, dirt, and heat

Some of the time

• Twist, pull and push torque wrench (8 lbs) up to 1.5 hour per shift
• Pushing and moving with assistance 50+ pounds approximately 2 times per week Contact with dust or fumes
• Climbing ladders & stairs
• Bending or stooping

Rarely

• Reaching above shoulder level
• Driving automotive equipment

Never

Lifting 50+ pounds

INDBLT

LI-RR2